| |
Broken Shower Handle
The covered button goes over a hole in the shower handle where the screw is.
Broken shower handle. Others like the one featured in this video have a small set screw somewhere on the handle. Cracked or broken shower handle step 1 remove the screw that holds you handle in place just as described in section 1. Broken shaft inside of the handle.
If you feel the shower handle getting loose pop off the screw cover and tighten the handle screw. One disadvantage to this. Just find the small hole on the underside of your handle.
Use a pocketknife to pry off the small round index cover from the shower s hot water faucet handle. The shaft seems to be the weakest piece of the handle and it is the most common piece to break. Some have a cover plate which can be pried off with a small screwdriver.
A shower stall with a single knob controlling the shower head contains fewer mechanical parts than a typical bathtub with a faucet and diverter that forces water up the pipe to the shower head when the steel rod is pulled up. The shaft can break from normal wear and tear but. Remove the screws holding the handle in place and lift it off of the handle stem.
Remove the handle and see if it is cracked or broken. In the worst case scenario a plastic handle can even break. Set the handle and screws on a flat surface to keep them aside until you re ready to screw them back in later.
Remove the screw holding the handle in place then pull the handle free of the valve stem. Cover the tub shower drain with a cloth to prevent small parts from dropping into the drainpipe. When replacing a shower faucet take off the shower head by turning the connecting nut counterclockwise with a pair of pliers.
Source : pinterest.com